Log in
Register
Home
Forums
New posts
Search forums
What's new
Featured content
New posts
New profile posts
Latest activity
News
Members
Current visitors
New profile posts
Search profile posts
Features
Log in
Register
What's new
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Menu
Install the app
Install
Reply to thread
Home
Forums
Pro Audio
Varsity
Bad mic shock
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Mike Sokol" data-source="post: 93262" data-attributes="member: 1989"><p>Re: Bad mic shock</p><p></p><p>'</p><p> The beauty of using a NCVT (Non Contact Voltage Tester) like a Fluke VoltAlert to test for hot-grounds on stage is that you don't need to measure "between" two pieces of gear to find out what's "hot". Since a NCVT is capacitively coupling to the earth below, it doesn't require an actual connection to earth ground like a standard voltmeter. So it's really obvious when you point it at a guitar amp with a "hot" chassis and it starts beeping. In fact, if the guitar amp chassis is sitting at 120 volts (easily possible) than a standard 90 to 1,000 volt VoltAlert will trigger from nearly a foot away from the amp. This allows you to point out to the talent that their guitar amp chassis (and any guitar plugged into it) is dangerously electrified. </p><p></p><p>And if you indeed have a floated ground on your entire PA system (very possible plugged into ungrounded genny power or mis-wired building power) then a VoltAlert will trigger anywhere close to any of the mics on stage. It's a really quick and obvious safety check that takes only seconds to perform. </p><p></p><p>Yup... I'll do a video of this when I get back from a gig this weekend. </p><p></p><p>Mike Sokol</p></blockquote><p></p>
[QUOTE="Mike Sokol, post: 93262, member: 1989"] Re: Bad mic shock ' The beauty of using a NCVT (Non Contact Voltage Tester) like a Fluke VoltAlert to test for hot-grounds on stage is that you don't need to measure "between" two pieces of gear to find out what's "hot". Since a NCVT is capacitively coupling to the earth below, it doesn't require an actual connection to earth ground like a standard voltmeter. So it's really obvious when you point it at a guitar amp with a "hot" chassis and it starts beeping. In fact, if the guitar amp chassis is sitting at 120 volts (easily possible) than a standard 90 to 1,000 volt VoltAlert will trigger from nearly a foot away from the amp. This allows you to point out to the talent that their guitar amp chassis (and any guitar plugged into it) is dangerously electrified. And if you indeed have a floated ground on your entire PA system (very possible plugged into ungrounded genny power or mis-wired building power) then a VoltAlert will trigger anywhere close to any of the mics on stage. It's a really quick and obvious safety check that takes only seconds to perform. Yup... I'll do a video of this when I get back from a gig this weekend. Mike Sokol [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Pro Audio
Varsity
Bad mic shock
Top
Bottom
Sign-up
or
log in
to join the discussion today!