Log in
Register
Home
Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
News
Members
Current visitors
New profile posts
Search profile posts
Features
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Menu
Install the app
Install
Reply to thread
Home
Forums
Low Earth Orbit
DIY Audio
Behringer EP2500 feed-through/daisy chaining. Possible?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Carl Klinkenborg" data-source="post: 214991" data-attributes="member: 12770"><p>Hi All, apologies if this is general knowledge, but I'm damned if I can find it, and Behringer technical support don't know either! I wish to use three EP2500 amps in bridged mono driven by one XLR output. Please don't laugh too hard - I've been using these amps successfully for twenty years!</p><p></p><p><strong>Can a single crossover output feed the first amp and out to the second one and thence to the third?</strong></p><p></p><p>The parallel mode and using the TRS 1/4" jacks come to mind, however the manual states on one page that the parallel switches must be 'off' in bridged mode, yet on another states that if they are 'on' then the signal feeds through. I'm not in a position to physically test this with my amps at present and was posting to see what other folks know or do - I am trying to avoid a distribution amp! Cheers, Carl.</p></blockquote><p></p>
[QUOTE="Carl Klinkenborg, post: 214991, member: 12770"] Hi All, apologies if this is general knowledge, but I'm damned if I can find it, and Behringer technical support don't know either! I wish to use three EP2500 amps in bridged mono driven by one XLR output. Please don't laugh too hard - I've been using these amps successfully for twenty years! [B]Can a single crossover output feed the first amp and out to the second one and thence to the third?[/B] The parallel mode and using the TRS 1/4" jacks come to mind, however the manual states on one page that the parallel switches must be 'off' in bridged mode, yet on another states that if they are 'on' then the signal feeds through. I'm not in a position to physically test this with my amps at present and was posting to see what other folks know or do - I am trying to avoid a distribution amp! Cheers, Carl. [/QUOTE]
Insert quotes…
Verification
Post reply
Home
Forums
Low Earth Orbit
DIY Audio
Behringer EP2500 feed-through/daisy chaining. Possible?
Top
Bottom
Sign-up
or
log in
to join the discussion today!