Reply to thread

Message

<blockquote data-quote="Tim Weaver" data-source="post: 122780" data-attributes="member: 317">Re: Behringer X32 Firmware v3.0 Feature RequestsFreely assignable inputs should be #1 on the list. Patching via bank of 8 is kinda dumb.Here&#039;s a couple more that I would like to see after playing with 2.0 for a while.When the desk is in gain share mode, it&#039;s not obvious where I should go to set channel gain. I would like to be able to hit the &quot;setup&quot; key and navigate to the preamps page, but then I want to be able to hit channel select buttons and have the focus put on to the proper gain knob. I detest the scrolling by banks of 4, then look at your channel, find the channel number, go back to the screen, find the right channel gain, then reach for the correct knob out of 4, but make sure the orange box is on the right bank of four, and adjust routine. I should be able to select a channel and twiddle a knob to adjust gain. Would make things so much faster.In that same boat, it would be nice to just place preamp gain control on the regular knob on the master desk. It should be an option to switch between gain/digi trim anyway.Other things I would like to see, are a regular old multiband compressor. Not one with auto make-up gain. And a Deesser that is freely tunable. If these could be on the channel dynamics instead of the rack it would be AWESOME.</blockquote>

[QUOTE="Tim Weaver, post: 122780, member: 317"] Re: Behringer X32 Firmware v3.0 Feature Requests Freely assignable inputs should be #1 on the list. Patching via bank of 8 is kinda dumb. Here's a couple more that I would like to see after playing with 2.0 for a while. When the desk is in gain share mode, it's not obvious where I should go to set channel gain. I would like to be able to hit the "setup" key and navigate to the preamps page, but then I want to be able to hit channel select buttons and have the focus put on to the proper gain knob. I detest the scrolling by banks of 4, then look at your channel, find the channel number, go back to the screen, find the right channel gain, then reach for the correct knob out of 4, but make sure the orange box is on the right bank of four, and adjust routine. I should be able to select a channel and twiddle a knob to adjust gain. Would make things so much faster. In that same boat, it would be nice to just place preamp gain control on the regular knob on the master desk. It should be an option to switch between gain/digi trim anyway. Other things I would like to see, are a regular old multiband compressor. Not one with auto make-up gain. And a Deesser that is freely tunable. If these could be on the channel dynamics instead of the rack it would be AWESOME. [/QUOTE]

Verification