Reply to thread

Message

<blockquote data-quote="TomHoward" data-source="post: 138473" data-attributes="member: 8179">Re: Behringer X32 Firmware v3.0 Feature RequestsI have found another two gripes with the X32 at the moment -Aux In Remaps - it would be nice to be able to remap to a higher AES50 value (i.e. 33-40 or 41-48) rather than only having options starting with AES50-1 - allowing for AES50 1-32 to be used for the usual 1-32 channels without having to remap. (I know I can remap the existing channels higher to allow 1-8 to be free but I&#039;m in the middle of a show run now and would rather not be forced to remap channels that are working (although I will...)Dual Mono GEQs - is there a way to copy between channels? As the effects unit is handled as a &#039;total&#039; copy/paste you can copy between one set of Dual QECs and paste on another - but not on channel 1 and paste to Channel 2 (for example as a starting point having EQ&#039;d one monitor.) Have to copy manually by comparing fader levels and then copy to further units. If you save as a Preset and re-load behaviour is the same.Thanks, Tom</blockquote>

[QUOTE="TomHoward, post: 138473, member: 8179"] Re: Behringer X32 Firmware v3.0 Feature Requests I have found another two gripes with the X32 at the moment - Aux In Remaps - it would be nice to be able to remap to a higher AES50 value (i.e. 33-40 or 41-48) rather than only having options starting with AES50-1 - allowing for AES50 1-32 to be used for the usual 1-32 channels without having to remap. [SIZE=1](I know I can remap the existing channels higher to allow 1-8 to be free but I'm in the middle of a show run now and would rather not be forced to remap channels that are working (although I will...)[/SIZE] Dual Mono GEQs - is there a way to copy between channels? As the effects unit is handled as a 'total' copy/paste you can copy between one set of Dual QECs and paste on another - but not on channel 1 and paste to Channel 2 (for example as a starting point having EQ'd one monitor.) Have to copy manually by comparing fader levels and then copy to further units. If you save as a Preset and re-load behaviour is the same. Thanks, Tom [/QUOTE]

Verification