i have 8 American DJ FlatPar QA12X LED Lights and I'm looking for an idea of 2 cases holding 4 lights each and I'm not sure what to go with. I'm thinking small trunks with wheels, ideas would be appreciated. Thanks
Case for Flat Pars
- Thread starter Kelly Johnson
- Start date
Re: Case for Flat Pars
We use old video projector cases (from back when 1200 lumen projectors weighed 80#) for fixtures like the FlatPar. Closest thing that came to mind is this: MSC-1648 . Order 1 small divider and put 4 units on each side. There will be some room on top for cords.
We use old video projector cases (from back when 1200 lumen projectors weighed 80#) for fixtures like the FlatPar. Closest thing that came to mind is this: MSC-1648 . Order 1 small divider and put 4 units on each side. There will be some room on top for cords.
Check the dimensions, but something like a Pelican 1620 should work. I can get 16 Chauvet Slimpar 56 into one, along with their associated IEC cables.
I have the audiopile ewi case. It is not long enough to leave the flat pars on their t bar. Next option I think I will be looking at a pair of keyboard cases.
Sent from my DROID RAZR HD
Sent from my DROID RAZR HD
Re: Case for Flat Pars
I built a simple wooden case on wheels for my lights. It also doubles as a light stand carrier or other thing (4 wedges fit on top too). I say I built it for $100-150.
Size: Length is roundly 49" (light bar is 48" and there is some play on each end), width is around 16" and height is about 22".
My light bars are all pre-wired up and the only thing I need to run up to them is 1-2 XLRs and 1 Extension cord.
I built a simple wooden case on wheels for my lights. It also doubles as a light stand carrier or other thing (4 wedges fit on top too). I say I built it for $100-150.
Size: Length is roundly 49" (light bar is 48" and there is some play on each end), width is around 16" and height is about 22".
My light bars are all pre-wired up and the only thing I need to run up to them is 1-2 XLRs and 1 Extension cord.
