How to figure length of a corner port
- Thread starter Tim Weaver
- Start date
Re: How to figure length of a corner port
I haven't played with modelling software in awhile.
I do recall one of the programs out there to do square ports. What you have there is half of a square port.
I haven't played with modelling software in awhile.
I do recall one of the programs out there to do square ports. What you have there is half of a square port.
Re: How to figure length of a corner port
Except for the fact that if your square port shares a wall of the cabinet it changes the math. This one shares 2 walls.
I ended up modeling a square shelf port and cut it in half. I will tweak it once I get them built.
Except for the fact that if your square port shares a wall of the cabinet it changes the math. This one shares 2 walls.
I ended up modeling a square shelf port and cut it in half. I will tweak it once I get them built.
Re: How to figure length of a corner port
Sounds good. With new designs you usually need to tweak the physical build anyway, as the model often only gets you close.
Sounds good. With new designs you usually need to tweak the physical build anyway, as the model often only gets you close.