Reply to thread

Message

<blockquote data-quote="Austin Dudley" data-source="post: 211562" data-attributes="member: 12693">Simply put I have a large system setup and the issue that I’m having is:On a clean frequency, and simple connection into the combiner and out to an antennaAs I walk the pack, (no audio) I am getting a very loud noise floor, (hisses, pops, intermodal sounds in some spots, etc)Things I have tried, swapping out all cables, switching between Omni, helical, and log periodic antennas, all have the same issues with no audio passing, however, when passing audio, even at a low level, most, if not all of the artifacts goes away. I am also able to walk about 300+ feet away from the antenna and still receive a strong signal.I’ve never had this problem from either the PSM1000 or the shure combiner before.&nbsp; Has anyone else encountered this problem or have a solution? Any thoughts would be appreciated.(PS. I am troubleshooting with 1 frequency as to eliminate any internal intermod...</blockquote>

[QUOTE="Austin Dudley, post: 211562, member: 12693"] Simply put I have a large system setup and the issue that I’m having is: On a clean frequency, and simple connection into the combiner and out to an antenna As I walk the pack, (no audio) I am getting a very loud noise floor, (hisses, pops, intermodal sounds in some spots, etc) Things I have tried, swapping out all cables, switching between Omni, helical, and log periodic antennas, all have the same issues with no audio passing, however, when passing audio, even at a low level, most, if not all of the artifacts goes away. I am also able to walk about 300+ feet away from the antenna and still receive a strong signal. I’ve never had this problem from either the PSM1000 or the shure combiner before. Has anyone else encountered this problem or have a solution? Any thoughts would be appreciated. (PS. I am troubleshooting with 1 frequency as to eliminate any internal intermod... [/QUOTE]

Verification