Does anyone know of an outfit that has fabricated rear rack rail supports for Powersoft K6/8/10/20 amplifiers? I could have a custom part made locally, but I'd rather give a few bucks to someone that has already expended the mental energy. I'm surprised that Powersoft doesn't offer a part directly given the modest depth of these amps.
Rear rack rail support for Powersoft amps
- Thread starter Rich Frembes
- Start date
Re: Rear rack rail support for Powersoft amps
Hey Rich,
I know Audiopile has some 1U rear support brackets, would those fit?
Hey Rich,
I know Audiopile has some 1U rear support brackets, would those fit?
Re: Rear rack rail support for Powersoft amps
Hi Rich,
I'm not sure how many amplifiers you are looking at putting together in a rack, but depending on what you are doing, you may want to have a look at the Middle Atlantic "Z-Rail Adaptor".
It looks like this may allow you to put screws sideways through the flanges on the back of the equipment to secure them to the rack rails.
[FONT=Verdana, Arial, Helvetica, sans-serif][/FONT]
Perhaps these would do what you are seeking?
Hi Rich,
I'm not sure how many amplifiers you are looking at putting together in a rack, but depending on what you are doing, you may want to have a look at the Middle Atlantic "Z-Rail Adaptor".
It looks like this may allow you to put screws sideways through the flanges on the back of the equipment to secure them to the rack rails.
[FONT=Verdana, Arial, Helvetica, sans-serif][/FONT]
Perhaps these would do what you are seeking?
Re: Rear rack rail support for Powersoft amps
It looks like their ERD1U-22 brackets will work. I ordered a few and will give them a try. Thanks for the tip David!
It looks like their ERD1U-22 brackets will work. I ordered a few and will give them a try. Thanks for the tip David!