This week's project, four panels each holding a 2'x 4'x2'' thick piece of Aurelex Studio Wedge foam.
Strips of Baltic Birch plywood, rabbet corner joints, and a dado all around at the 2'' dpeth point to fit a back panel of 1/4'' pegboard.
Still light enough that I should be able to just set a pair of wall anchors and screws for each panel, and use some picture frame wire to hang them where needed, when needed.
Still have a couple sheets of the foam left over to expand the collection at some point, we'll see what happens with these.
Best regards,
John
Strips of Baltic Birch plywood, rabbet corner joints, and a dado all around at the 2'' dpeth point to fit a back panel of 1/4'' pegboard.
Still light enough that I should be able to just set a pair of wall anchors and screws for each panel, and use some picture frame wire to hang them where needed, when needed.
Still have a couple sheets of the foam left over to expand the collection at some point, we'll see what happens with these.
Best regards,
John