Reply to thread

Message

<blockquote data-quote="Pauly Mel" data-source="post: 100441" data-attributes="member: 2406">Advice re Firewire Interface glitchesHi All,I&#039;m seeking some advice on continual issues with recording via firewire with the X32First - the environment...WIndows 7/64 (latest updates) 
Intel i7 CPU
16 Gig Ram
SSD Hard Disks
Solid as a rock (Except for these issues)

X32 - Using Firewire card 

Cubase 7.X (Latest version) 

The Problem(s):1/ Every time I start the computer, before I open Cubase, I need to select a new buffer value in the X32 Firewire Application. Lower or higher doesn&#039;t seem to matter.. as long as I change it. From there, I can usually open Cubase, open a project, and it&#039;ll work ok.

Sometimes however it doesn&#039;t... so I need to repeat the process and it works eventually.

(Edit) - When I say &#039;Work&#039; - I mean playback sound... Midi works fine, but no audio.

2/ Sometimes, while playing back, the sound will start sounding &#039;digital&#039; (for want of a better term).... and it gets worse and worse until playback just stops... I then get into the x32 control panel, reset the parameters again, and off it goes.&nbsp; Occasionally, it just stops without going all &#039;Dalek&#039; on me... same procedure to fix.

I haven&#039;t complained about this before as I was just &#039;living with it&#039; however it&#039;s getting more and more common now so I seek answers.Thanks for any advicePauly</blockquote>

[QUOTE="Pauly Mel, post: 100441, member: 2406"] Advice re Firewire Interface glitches Hi All, I'm seeking some advice on continual issues with recording via firewire with the X32 First - the environment...[INDENT]WIndows 7/64 (latest updates) Intel i7 CPU 16 Gig Ram SSD Hard Disks Solid as a rock (Except for these issues) X32 - Using Firewire card Cubase 7.X (Latest version) [/INDENT] The Problem(s):[INDENT]1/ Every time I start the computer, before I open Cubase, I need to select a new buffer value in the X32 Firewire Application. Lower or higher doesn't seem to matter.. as long as I change it. From there, I can usually open Cubase, open a project, and it'll work ok. Sometimes however it doesn't... so I need to repeat the process and it works eventually. (Edit) - When I say 'Work' - I mean playback sound... Midi works fine, but no audio. 2/ Sometimes, while playing back, the sound will start sounding 'digital' (for want of a better term).... and it gets worse and worse until playback just stops... I then get into the x32 control panel, reset the parameters again, and off it goes. Occasionally, it just stops without going all 'Dalek' on me... same procedure to fix. [/INDENT] I haven't complained about this before as I was just 'living with it' however it's getting more and more common now so I seek answers. Thanks for any advice Pauly [/QUOTE]

Verification