Reply to thread

Message

<blockquote data-quote="Robert Goldberg" data-source="post: 108315" data-attributes="member: 5161">Re: X32 as monitorHi all. I need some help. I have only had my X32 for about 3 months. Doing well with it but still have lots to learn. Here&#039;s the setup: I have 2 matrix sends, LINK&#039;ed, that control my top mains. I have EQ set up with filters to only allow the top end frequencies to go to those Matrix sends. Then I have a third matrix send which I use for subs. It is also set up with filters to only allow subwoofer frequencies to go to that Matrix send. All three matrix sends are fed by the LR channel. The problem is with this setup I can&#039;t separately control the volume of the left and right side of the mains because the matrix sends are linked. I have some venues I play in that don&#039;t allow for both sides of the PA being an equal distance to the dance floor/audience. Is there a way I can gain separate volume control over the two sides without a major adjustment to how I have the board set up to use. I tried unlinking the two matrix channels but there doesn&#039;t appear to be any pan setting (at least I can&#039;t find one) when I do that so when using it that way it seemed like it was a mono set up which is not what I want.Help????&nbsp;&nbsp; Thanks .............. Rob</blockquote>

[QUOTE="Robert Goldberg, post: 108315, member: 5161"] Re: X32 as monitor Hi all. I need some help. I have only had my X32 for about 3 months. Doing well with it but still have lots to learn. Here's the setup: I have 2 matrix sends, LINK'ed, that control my top mains. I have EQ set up with filters to only allow the top end frequencies to go to those Matrix sends. Then I have a third matrix send which I use for subs. It is also set up with filters to only allow subwoofer frequencies to go to that Matrix send. All three matrix sends are fed by the LR channel. The problem is with this setup I can't separately control the volume of the left and right side of the mains because the matrix sends are linked. I have some venues I play in that don't allow for both sides of the PA being an equal distance to the dance floor/audience. Is there a way I can gain separate volume control over the two sides without a major adjustment to how I have the board set up to use. I tried unlinking the two matrix channels but there doesn't appear to be any pan setting (at least I can't find one) when I do that so when using it that way it seemed like it was a mono set up which is not what I want. Help???? Thanks .............. Rob [/QUOTE]

Verification