Reply to thread

Message

<blockquote data-quote="John DiNicola" data-source="post: 109137" data-attributes="member: 2061">Re: Source Channel from Bus Out for Recording?Dear Simon,Changing the source of the input channel to a bus will not change what is going out of the XUF card, as it is set to tap the mic preamps just after A/D conversion by defaultAs Nick says, you need to change the settings on the &quot;Card Out&quot; page of the ROUTING menu.There are a couple of ways to go about this, but using the P16 outputs is a great way to go if you are not using the P16 system. On the &quot;card out&quot; page, change one of your banks of 8 outputs to &quot;P16 1-8&quot;.Then go to the &quot;P16 out&quot; page, where you can individually assign any signals you want to the first 8 P16 outputs. These assignments will then route to the card outputs to your computer. The advantage to this method is that you can assign your mix buses to the first two P16 outputs, and still use the other 6 to assign direct output from channels. This way you are not using a whole bank of 8 outputs for a pair of mix buses. Hope it helps!</blockquote>

[QUOTE="John DiNicola, post: 109137, member: 2061"] Re: Source Channel from Bus Out for Recording? Dear Simon, Changing the source of the input channel to a bus will not change what is going out of the XUF card, as it is set to tap the mic preamps just after A/D conversion by default As Nick says, you need to change the settings on the "Card Out" page of the ROUTING menu. There are a couple of ways to go about this, but using the P16 outputs is a great way to go if you are not using the P16 system. On the "card out" page, change one of your banks of 8 outputs to "P16 1-8". Then go to the "P16 out" page, where you can individually assign any signals you want to the first 8 P16 outputs. These assignments will then route to the card outputs to your computer. The advantage to this method is that you can assign your mix buses to the first two P16 outputs, and still use the other 6 to assign direct output from channels. This way you are not using a whole bank of 8 outputs for a pair of mix buses. Hope it helps! [/QUOTE]

Verification