Reply to thread

Message

<blockquote data-quote="Nick Davis" data-source="post: 109180" data-attributes="member: 1713">Re: Source Channel from Bus Out for Recording?Before I answer – one&nbsp; thing to remember / note that although you can route post fader via a bus to the P16 any send / return effects will not be included unless&nbsp; you also route the output from the FX ( return) to the bus – but be careful not to return to the effects busses.Concerning the card outs – yes only blocks of 8. But there is flexibility in what goesto each P16 out.So if you assign the card outs as you said&nbsp;1-8 = Local 1-8&nbsp; (or aes50 if s16)9-16 = Local 9-1617-24&nbsp; =P16 1-825-32 = P16 9-16So card outs&nbsp; 1 to 16 will now have the direct outputs for Ch 1-16In the Routing for the P16&nbsp; Set P16&nbsp; out 01 to Direct out Ch 17 ( pre EQ)P16 out&nbsp; 02 to Direct Ch18 (pre Eq)you should now have all 18 channel direct outs pre eq.Set the other P16 outs to your busses.You can check all this using xeditSorry about the spacing – as cannot type directly into forum at moment did off-line and pasted!someone correct me if I have got this wrong!</blockquote>

[QUOTE="Nick Davis, post: 109180, member: 1713"] Re: Source Channel from Bus Out for Recording? Before I answer – one thing to remember / note that although you can route post fader via a bus to the P16 any send / return effects will not be included unless you also route the output from the FX ( return) to the bus – but be careful not to return to the effects busses. Concerning the card outs – yes only blocks of 8. But there is flexibility in what goes to each P16 out. So if you assign the card outs as you said 1-8 = Local 1-8 (or aes50 if s16) 9-16 = Local 9-16 17-24 =P16 1-8 25-32 = P16 9-16 So card outs 1 to 16 will now have the direct outputs for Ch 1-16 In the Routing for the P16 Set P16 out 01 to Direct out Ch 17 ( pre EQ) P16 out 02 to Direct Ch18 (pre Eq) you should now have all 18 channel direct outs pre eq. Set the other P16 outs to your busses. You can check all this using xedit Sorry about the spacing – as cannot type directly into forum at moment did off-line and pasted! someone correct me if I have got this wrong! [/QUOTE]

Verification