Reply to thread

Message

<blockquote data-quote="Per SÃ¸vik" data-source="post: 121030" data-attributes="member: 1285">Re: S16 and phantom popsThe thing is, and I don&#039;t doubt that you are experiencing this, I have checked, and I don&#039;t get this behaviour.When I set the phantom on A1-16, move to A17-32 or local 1-16, make settings there and go back, the settings are intact.If I go into the preamp page, the settings tally with what I&#039;ve set, and most importantly, nothing changes on the S16 when switching back and forth. Even if I turn off the console, the S16 phantom stays on.Saving two scenes on the console and going back and forth, no change.Loading show prepared in the exact same manner in X32-Edit, no change.So what am I doing differently from you guys? or rather, if you don&#039;t mind me asking, are you guys doing wrong?Anyone care to post a couple of scenes or a show where the problem manifests itself?</blockquote>

[QUOTE="Per SÃ¸vik, post: 121030, member: 1285"] Re: S16 and phantom pops The thing is, and I don't doubt that you are experiencing this, I have checked, and I don't get this behaviour. When I set the phantom on A1-16, move to A17-32 or local 1-16, make settings there and go back, the settings are intact. If I go into the preamp page, the settings tally with what I've set, and most importantly, nothing changes on the S16 when switching back and forth. Even if I turn off the console, the S16 phantom stays on. Saving two scenes on the console and going back and forth, no change. Loading show prepared in the exact same manner in X32-Edit, no change. So what am I doing differently from you guys? or rather, if you don't mind me asking, are you guys doing wrong? Anyone care to post a couple of scenes or a show where the problem manifests itself? [/QUOTE]

Verification