Reply to thread

Message

<blockquote data-quote="Shane Presley" data-source="post: 121388" data-attributes="member: 110">Re: iPAD 1&nbsp; - no longer supportedHi Dan, welcome to the forum, you have found a wealth of information here, I learn from these guys every dayI hope I might be able to help you sort out some of your &quot;hit list peeves&quot;First off, copy and paste... Select the channel (all attributes of the channel) or just hit the view of an attribute you wish to copy. Press utility and then copy...Select the destination channel and hit paste... Seems easy enough.Graphics can be copied a to b, but not slot to slot... It&#039;s rumoured it&#039;s fixed in v2.02 firmware ( slot to slot copy)You are correct about user buttons to get to graphics, I set user key set c to page jump to effect slots 5,6...Again hoping in the new firmware it will allow you to page jump to a SPECIFIC page.Anyway congrats on your success with the console...</blockquote>

[QUOTE="Shane Presley, post: 121388, member: 110"] Re: iPAD 1 - no longer supported Hi Dan, welcome to the forum, you have found a wealth of information here, I learn from these guys every day I hope I might be able to help you sort out some of your "hit list peeves" First off, copy and paste... Select the channel (all attributes of the channel) or just hit the view of an attribute you wish to copy. Press utility and then copy... Select the destination channel and hit paste... Seems easy enough. Graphics can be copied a to b, but not slot to slot... It's rumoured it's fixed in v2.02 firmware ( slot to slot copy) You are correct about user buttons to get to graphics, I set user key set c to page jump to effect slots 5,6... Again hoping in the new firmware it will allow you to page jump to a SPECIFIC page. Anyway congrats on your success with the console... [/QUOTE]

Verification