Reply to thread

Message

<blockquote data-quote="Klaus Mock" data-source="post: 122061" data-attributes="member: 2891">Re: Bus/monitor volumeHi thorsten,You have to distinguish between the configuration of the bus sind mode, done via the bus&#039;s home page and the&nbsp; how the bus mains is send to the output, done via routing page. The first will determine how the signals of the input channels will be send to the bus, pre or post fader and so on. This is what you know from the analog desks. Here you should choose pre fader or pre eq for monitor purpose.when you assign the output of the bus to a physical output, lets say mixbus 1 should leave the desk via local output 1, the you have to do this configuration at the routing page, outputs. There you can not only assign for each physical output the source, in our example mixbus 1, but also the tappoint of the signal. This is a little bit different to most analog desks as ananlog desks usually are always configured to post aux master. Here you have to choose post fader so that you can control the output level with the bus master fader. you can see this configuration if you initialize the scene to the defaults.</blockquote>

[QUOTE="Klaus Mock, post: 122061, member: 2891"] Re: Bus/monitor volume Hi thorsten, You have to distinguish between the configuration of the bus sind mode, done via the bus's home page and the how the bus mains is send to the output, done via routing page. The first will determine how the signals of the input channels will be send to the bus, pre or post fader and so on. This is what you know from the analog desks. Here you should choose pre fader or pre eq for monitor purpose. when you assign the output of the bus to a physical output, lets say mixbus 1 should leave the desk via local output 1, the you have to do this configuration at the routing page, outputs. There you can not only assign for each physical output the source, in our example mixbus 1, but also the tappoint of the signal. This is a little bit different to most analog desks as ananlog desks usually are always configured to post aux master. Here you have to choose post fader so that you can control the output level with the bus master fader. you can see this configuration if you initialize the scene to the defaults. [/QUOTE]

Verification