Reply to thread

Message

<blockquote data-quote="Per SÃ¸vik" data-source="post: 123222" data-attributes="member: 1285">Re: Updated X32 rack... iPad help!!OK, first you need to find the address of the router, and assuming you are too much of a dummy to change stuff on the router, and it hasn&#039;t had DHCP turned off, connect your iPad to the router.Start up X32mix and the connection box should pop up, otherwise open the setup, and the values will be in the first tab. &quot;This iPad&quot; will show the address of the iPad, now enter the same address in the &quot;X32 Console&quot; box, but change the last number, so if the iPad is 192.168.1.7 , enter 192.168.1.20 for the console.On the console, go into SETUP - network and enter the same number for ip address: 192.168.1.20 in this case. push the encoder at the end to assign the address (don&#039;t know if it actually makes a difference)Enter 255.255.255.0 in the mask section and just leave the gateway part blank.On the iPad, hit &quot;connect&quot; in the pop-up window or the Setup - iPAD tab</blockquote>

[QUOTE="Per SÃ¸vik, post: 123222, member: 1285"] Re: Updated X32 rack... iPad help!! OK, first you need to find the address of the router, and assuming you are too much of a dummy to change stuff on the router, and it hasn't had DHCP turned off, connect your iPad to the router. Start up X32mix and the connection box should pop up, otherwise open the setup, and the values will be in the first tab. "This iPad" will show the address of the iPad, now enter the same address in the "X32 Console" box, but change the last number, so if the iPad is 192.168.1.7 , enter 192.168.1.20 for the console. On the console, go into SETUP - network and enter the same number for ip address: 192.168.1.20 in this case. push the encoder at the end to assign the address (don't know if it actually makes a difference) Enter 255.255.255.0 in the mask section and just leave the gateway part blank. On the iPad, hit "connect" in the pop-up window or the Setup - iPAD tab [/QUOTE]

Verification