Reply to thread

Message

<blockquote data-quote="Tim McCulloch" data-source="post: 130409" data-attributes="member: 67">Re: X32 Discussion - new firmwareSort of.You have to assign input capability in blocks of 8 channels (1-8, 9-16, 17-24, etc).&nbsp; What this means is that the mixer will access the assigned block of inputs and allow you, on a channel-by-channel basis, to pick where a channel&#039;s input comes from.&nbsp; Note that the assignment of blocks of 8 inputs, however, is inviolate.&nbsp; Even if you don&#039;t use all of them, you&#039;re still stuck with those 8 inputs being a part of the available inputs.The &quot;AUX INPUTS&quot; are mono or linkable for stereo, except for AUX 7-8, which are dedicated to the USB playback of the mixer&nbsp; and cannot be re-mapped.&nbsp; There is an AUX In REMAP in the Routing &gt; HOME tab.Spend a little bit of time in front of the mixer and you&#039;ll see the limitations and flexibility of this method.So to answer your last question, the answer is &quot;Sort of... not on a granular level..... no.... .yes...&quot;&nbsp; It depends on exactly where you need to connect mics &amp; DIs to physical inputs and then have those show up on the desk.&nbsp; In theory you can have multiple S16s and switch between inputs in banks of 8 via scene automation (Routing &gt; HOME &gt; Inputs).To pick where a mixer input gets it&#039;s signal, go to the Home &gt; CONFIG tab and find the Source window.&nbsp; Note how this interacts with the physical inputs chosen in the Routing &gt; Home tab.</blockquote>

[QUOTE="Tim McCulloch, post: 130409, member: 67"] Re: X32 Discussion - new firmware Sort of. You have to assign input capability in blocks of 8 channels (1-8, 9-16, 17-24, etc). What this means is that the mixer will access the assigned block of inputs and allow you, on a channel-by-channel basis, to pick where a channel's input comes from. Note that the assignment of blocks of 8 inputs, however, is inviolate. Even if you don't use all of them, you're still stuck with those 8 inputs being a part of the available inputs. The "AUX INPUTS" are mono or linkable for stereo, except for AUX 7-8, which are dedicated to the USB playback of the mixer and cannot be re-mapped. There is an AUX In REMAP in the Routing > HOME tab. Spend a little bit of time in front of the mixer and you'll see the limitations and flexibility of this method. So to answer your last question, the answer is "Sort of... not on a granular level..... no.... .yes..." It depends on exactly where you need to connect mics & DIs to physical inputs and then have those show up on the desk. In theory you can have multiple S16s and switch between inputs in banks of 8 via scene automation (Routing > HOME > Inputs). To pick where a mixer input gets it's signal, go to the Home > CONFIG tab and find the Source window. Note how this interacts with the physical inputs chosen in the Routing > Home tab. [/QUOTE]

Verification