Reply to thread

Message

<blockquote data-quote="Dan Mortensen" data-source="post: 134013" data-attributes="member: 2826">Re: X32 rack won&#039;t boot from usb to update firmwareSetting Up Graphic EQ&#039;s in Effects Slots 1-4A friend of mine is at a gig RIGHT NOW and is trying to get 10 monitor mixes set up on his console, which was just updated to 2.10. FX slots 5-8 are behaving normally (insert button on right to activate inserted graphics).FX slots 1-4 allow him to select a graphic and select its source (bus 1 for example). The graphic meters as if signal is going through it, but it has no affect on the sound of his monitors when he adjusts the EQ level. There are no insert buttons showing to allow the graphic to be inserted into bus 1.Any ideas how to get this working for him?TIA.EDIT: He just called back (3 seconds after I hit POST) and said that scrolling past the Buses generates a Bus x INSERT list.So never mind.</blockquote>

[QUOTE="Dan Mortensen, post: 134013, member: 2826"] Re: X32 rack won't boot from usb to update firmware [B]Setting Up Graphic EQ's in Effects Slots 1-4[/B] A friend of mine is at a gig [B]RIGHT NOW[/B] and is trying to get 10 monitor mixes set up on his console, which was just updated to 2.10. FX slots 5-8 are behaving normally (insert button on right to activate inserted graphics). FX slots 1-4 allow him to select a graphic and select its source (bus 1 for example). The graphic meters as if signal is going through it, but it has no affect on the sound of his monitors when he adjusts the EQ level. There are no insert buttons showing to allow the graphic to be inserted into bus 1. Any ideas how to get this working for him? TIA. EDIT: He just called back (3 seconds after I hit POST) and said that scrolling past the Buses generates a Bus x INSERT list. So never mind. [/QUOTE]

Verification