Reply to thread

Message

<blockquote data-quote="Kaido Haavandi" data-source="post: 138153" data-attributes="member: 5857">Re: New Stage BoxesHey guys, I might need help/advice with something. Got my M32R and I have an issue with fader calibration. As far as I could check all the M32 full desks within my reach have the same feature and I cannot think of this as anything else but a bug or sloppy manufacturing. Plus I think some X32&#039;s have the same issue to some extent.The problem is that the fader motors don&#039;t carry the faders all the way down. This is experienced when I have two channels linked and use one of the faders to drag the other one down. The one carried down by the motor stops at -50 indicator, that&#039;s over 10mm from bottom position. Same happens when I edit the channel level through software: the motor just doesn&#039;t react between -87dB and -53dB. When I go to a layer that has the faders at &quot;lowest&quot; position and the motors snap the faders there, it&#039;s still a few millimeters from the bottom.Funnily enough everyone I asked hadn&#039;t paid attention to it so it might not be a big issue live, but c&#039;mon...[ATTACH]154087[/ATTACH]The picture illustrates what I said above. Ch1 and ch2 are linked and ch1 is dragged down manually. Notice the difference between ch2 and the rest of the channels which have been brought down to a position the console thinks of as bottom position.I guess I&#039;m asking for advice: is this something to submit to CARE and does this seem like something that can be fixed at all? Maybe I am making fuss over nothing?</blockquote>

[QUOTE="Kaido Haavandi, post: 138153, member: 5857"] Re: New Stage Boxes Hey guys, I might need help/advice with something. Got my M32R and I have an issue with fader calibration. As far as I could check all the M32 full desks within my reach have the same feature and I cannot think of this as anything else but a bug or sloppy manufacturing. Plus I think some X32's have the same issue to some extent. The problem is that the fader motors don't carry the faders all the way down. This is experienced when I have two channels linked and use one of the faders to drag the other one down. The one carried down by the motor stops at -50 indicator, that's over 10mm from bottom position. Same happens when I edit the channel level through software: the motor just doesn't react between -87dB and -53dB. When I go to a layer that has the faders at "lowest" position and the motors snap the faders there, it's still a few millimeters from the bottom. Funnily enough everyone I asked hadn't paid attention to it so it might not be a big issue live, but c'mon... [ATTACH=CONFIG]154087.vB5-legacyid=12009[/ATTACH] The picture illustrates what I said above. Ch1 and ch2 are linked and ch1 is dragged down manually. Notice the difference between ch2 and the rest of the channels which have been brought down to a position the console thinks of as bottom position. I guess I'm asking for advice: is this something to submit to CARE and does this seem like something that can be fixed at all? Maybe I am making fuss over nothing? [/QUOTE]

Verification