Reply to thread

Message

<blockquote data-quote="Daniel Rheaume" data-source="post: 138677" data-attributes="member: 9043">Re: X32 DiscussionHi Timo!&nbsp;Thanks for your quick reply!Yes, that was my bad! There is NO hum. it&#039;s ONLY hiss. That was a typo on my part to have used both terms.Yes, I think we are talking about the same routing. I&#039;m sending my master L/R out to XLR outputs 7&amp;8. Xlr&#039;s 7&amp;8 are connected to the Mackie&#039;s.&nbsp;Yes, I am connecting the bookshelf speakers that are powered by the Adcom to the TRS Monitor output of the mixer.&nbsp;They are however, unbalanced RCA -&gt; 1/4&quot; cables. Despite the unbalanced connection, the monitor out is very quiet.Ok, I will try this as soon as I can...I will be on a flyaway gig over the weekend so if I can&#039;t test it tomorrow, I may not get a chance to test until Monday.I will keep you updated.Thanks!!-Daniel</blockquote>

[QUOTE="Daniel Rheaume, post: 138677, member: 9043"] Re: X32 Discussion Hi Timo! Thanks for your quick reply! Yes, that was my bad! There is NO hum. it's ONLY hiss. That was a typo on my part to have used both terms. Yes, I think we are talking about the same routing. I'm sending my master L/R out to XLR outputs 7&8. Xlr's 7&8 are connected to the Mackie's. Yes, I am connecting the bookshelf speakers that are powered by the Adcom to the TRS Monitor output of the mixer. They are however, unbalanced RCA -> 1/4" cables. Despite the unbalanced connection, the monitor out is very quiet. Ok, I will try this as soon as I can...I will be on a flyaway gig over the weekend so if I can't test it tomorrow, I may not get a chance to test until Monday. I will keep you updated. Thanks!! -Daniel [/QUOTE]

Verification