Reply to thread

Message

<blockquote data-quote="Daniel Rheaume" data-source="post: 138819" data-attributes="member: 9043">Re: X32 DiscussionDan, &nbsp;Thanks for your reply.I agree, considering both the monitor out and one of my bus outs are very quiet, I have no reason to believe the 7/8 Master LR out going to the Mackie&#039;s is not performing correctly... I&#039;m fairly certain the hiss is a problem that can be remedied with some inline pads, which I intend to build soon. I still need to check running the cables straight to the Mackies instead of through the snake (in case that&#039;s adding noise) but I&#039;ve been very busy preparing to move, so it&#039;s on hold for a minute.Just to rephrase my last post though, my confusion is more in how there is any hiss at all coming when the channel is muted and faders are down. So, purely for knowledge, are the faders and mutes all just digital 1&#039;s and 0&#039;s not being passed to the D/A converter, while the mixer itself is actually sending a full gain signal at all times?Thanks!-Daniel</blockquote>

[QUOTE="Daniel Rheaume, post: 138819, member: 9043"] Re: X32 Discussion Dan, Thanks for your reply. I agree, considering both the monitor out and one of my bus outs are very quiet, I have no reason to believe the 7/8 Master LR out going to the Mackie's is not performing correctly... I'm fairly certain the hiss is a problem that can be remedied with some inline pads, which I intend to build soon. I still need to check running the cables straight to the Mackies instead of through the snake (in case that's adding noise) but I've been very busy preparing to move, so it's on hold for a minute. Just to rephrase my last post though, my confusion is more in how there is any hiss at all coming when the channel is muted and faders are down. So, purely for knowledge, are the faders and mutes all just digital 1's and 0's not being passed to the D/A converter, while the mixer itself is actually sending a full gain signal at all times? Thanks! -Daniel [/QUOTE]

Verification