Reply to thread

Message

<blockquote data-quote="Christian Boche" data-source="post: 58263" data-attributes="member: 1698">re: X32 DiscussionGood question. Look at the block schematics in the quickstart guide, it shows all the options. Basically all signal taps are behind the Gate and the HiPassFilter. Than you can select under &quot;sends&quot;:Post EQ: tap is behind the EQ but before the compressor. You can tap it with the compressor, this is determined by the setting you do in the channel config page of each channel. There you can decide, which order EQ&amp;Compression should have. If you set the dynamic before the EQ than &quot;PostEQ&quot; is after EQ&amp;Dyn. If you set the EQ before Dyn., that set&#039;s &quot;PostEQ&quot; before the Compressor. I&#039;m quite sure, that nobody get&#039;s, what I&#039;m trying to say here.:?~:-?~:???: So, download the QS Guide und look at the schematics.:roll:<a href="http://www.behringer.com/assets/X32_WebBrochure.pdf" target="_blank">http://www.behringer.com/assets/X32_WebBrochure.pdf</a>To sum it up: Gate&amp;HPF are always in the mixbus, the rest is fully modifiable<img src="https://cdn.jsdelivr.net/joypixels/assets/8.0/png/unicode/64/1f642.png" class="smilie smilie--emoji" loading="lazy" width="64" height="64" alt=":-)" title="Smile&nbsp; &nbsp; :-)"&nbsp; data-smilie="1"data-shortname=":-)" />Christian</blockquote>

[QUOTE="Christian Boche, post: 58263, member: 1698"] re: X32 Discussion Good question. Look at the block schematics in the quickstart guide, it shows all the options. Basically all signal taps are behind the Gate and the HiPassFilter. Than you can select under "sends": Post EQ: tap is behind the EQ but before the compressor. You can tap it with the compressor, this is determined by the setting you do in the channel config page of each channel. There you can decide, which order EQ&Compression should have. If you set the dynamic before the EQ than "PostEQ" is after EQ&Dyn. If you set the EQ before Dyn., that set's "PostEQ" before the Compressor. I'm quite sure, that nobody get's, what I'm trying to say here.:?~:-?~:???: So, download the QS Guide und look at the schematics.:roll: [URL]http://www.behringer.com/assets/X32_WebBrochure.pdf[/URL] To sum it up: Gate&HPF are always in the mixbus, the rest is fully modifiable:-) Christian [/QUOTE]

Verification