Reply to thread

Message

<blockquote data-quote="Per SÃ¸vik" data-source="post: 59297" data-attributes="member: 1285">re: X32 DiscussionI was hoping that the X32 would have something similar to what you find on the DMX-R100, where there are a couple of modes that outputs all faders and rotaries, allowing you to record movements and/or control the DAW fader automation etc. The DMX-R100 will also respond to the same midi signals when played back. It is not Mackie control, so a template needs to be built for each DAW.Anyway, since all movements are sent and received through the LAN port, it should be possible to make a program that can route this to and from DAW, letting the DAW take the place of the XControl as far as the X32 is concerned. Let&#039;s see how much information Behringer makes available about the remote control protocol. My programming days are very much in the past, but this might be a fun project to undertake if there are no other, more proficient takers.</blockquote>

[QUOTE="Per SÃ¸vik, post: 59297, member: 1285"] re: X32 Discussion I was hoping that the X32 would have something similar to what you find on the DMX-R100, where there are a couple of modes that outputs all faders and rotaries, allowing you to record movements and/or control the DAW fader automation etc. The DMX-R100 will also respond to the same midi signals when played back. It is not Mackie control, so a template needs to be built for each DAW. Anyway, since all movements are sent and received through the LAN port, it should be possible to make a program that can route this to and from DAW, letting the DAW take the place of the XControl as far as the X32 is concerned. Let's see how much information Behringer makes available about the remote control protocol. My programming days are very much in the past, but this might be a fun project to undertake if there are no other, more proficient takers. [/QUOTE]

Verification