re: X32 Discussion
Hey Everyone,
Been a long time lurker here, but finally joined after following this thread from the beginning! I ordered my X32 back in January and finally go it this week. So far it's been as I have expected and I'm really enjoying using the unit.
I have a few questions that for some reason I can't seem to figure out. Any help would be greatly appreciated.
I have mix bus 1 set up as pre fader and I plan to use it as a monitor mix. When I add the input channels I want to send to the monitor, all is well...except, when I go to the right side of the console and I select the Bus 1-8 button, as I move the bus 1 fader, it does not change the overall volume of my mix in the monitor. Can anyone tell me where I may be going wrong? I would like to set my mix up and use the bus fader to control the overall volume. Even if I have the fader pulled all the way down, I still get sound in the monitor.
The other question I can't seem to figure out is this. If I have reverb on bus 13 and I am using it to send to multiple vocal channels. Some of my clients like to have the reverb in their monitor mix. How can I add the reverb in a monitor mix if someone would like it? Personally I don't like reverb in monitors, but some do.
I have read the Quick Start Guide and the user manual, but I can't figure out answers to these questions or where I could be going wrong.
Thanks for everyone who has contributed to this post, it's been very helpful.
Also, FYI, I have tried calling the Behringer tech support which, as of this week, has moved to Las Vegas. Low and behold, the guy I have spoken to 3 times now has informed me they just got their X32 mixer this week and answering my questions has been very slow. It's been 2 days now and no one there has been able to figure out my reverb question.
Thanks to all!
