Reply to thread

Message

<blockquote data-quote="Joe Sanborn" data-source="post: 65032" data-attributes="member: 2062">re: X32 DiscussionHi Shane,One way to do this:- When using 2 X32s together as you described, the console that has the Mics physically connected to it is the one controlling the gain (in your scenario, this would be the monitor console).- The FOH console would have a digital trim of + or - 12dB.- To assign the FOH Main Outpu to the outputs on the Monitor desk takes a few steps.On the FOH Console:- On the ROUTING menu, go to the &quot;analog out&quot; tab. Assign your Main LR to Out 1+2.- Tab over to the &quot;AES50&quot; tab (use A or B depending which AES50 port you are using on the FOH console)- Route &quot;Out 1-8&quot; to Outputs 1-8.On the Monitor Console:- First you need to bring the signal in from the AES50 stream before it can be re-routed to the console&#039;s outputs.- Go to the &quot;home&quot; screen of the ROUTING menu.- The last column will allow you to bring AES50 into Aux 1-4.- Now, tab over to the &quot;analog out&quot; page.- Chose the outputs you wish to use for Mains, and assign them to DirOut Aux 1 and DirOut Aux 2.- On this same page, you can assign the mix busses from your MON console to the appropriate outputs.I am checking with our development team if we can add the ability to directly assign an AES50 channel to a physical analog output.BestJoe SanbornManager, Channel MarketingMUSIC GroupBEHRINGER</blockquote>

[QUOTE="Joe Sanborn, post: 65032, member: 2062"] re: X32 Discussion Hi Shane, [B]One way to do this: [/B]- When using 2 X32s together as you described, the console that has the Mics physically connected to it is the one controlling the gain (in your scenario, this would be the monitor console). - The FOH console would have a digital trim of + or - 12dB. - To assign the FOH Main Outpu to the outputs on the Monitor desk takes a few steps. [B] On the FOH Console: [/B]- On the ROUTING menu, go to the "analog out" tab. Assign your Main LR to Out 1+2. - Tab over to the "AES50" tab (use A or B depending which AES50 port you are using on the FOH console) - Route "Out 1-8" to Outputs 1-8. [B] On the Monitor Console: [/B]- First you need to bring the signal in from the AES50 stream before it can be re-routed to the console's outputs. - Go to the "home" screen of the ROUTING menu. - The last column will allow you to bring AES50 into Aux 1-4. - Now, tab over to the "analog out" page. - Chose the outputs you wish to use for Mains, and assign them to DirOut Aux 1 and DirOut Aux 2. - On this same page, you can assign the mix busses from your MON console to the appropriate outputs. [B]I am checking with our development team if we can add the ability to directly assign an AES50 channel to a physical analog output.[/B] Best Joe Sanborn Manager, Channel Marketing MUSIC Group BEHRINGER [/QUOTE]

Verification