Reply to thread

Message

<blockquote data-quote="Donald P Leaman" data-source="post: 65358" data-attributes="member: 1762">re: X32 DiscussionTry this:Press the &quot;Sends on Fader&quot; buttonPress the &quot;Home&quot; button next to the LCD screenUse the right-arrow to move to the &quot;Config&quot; tabSelect the bus you want to configure by hitting it&#039;s &quot;Select&quot; button in the master section (make sure you&#039;re on &quot;bus 1-8&quot; or &quot;bus 9-16&quot;)Now, the 3rd rotary knob below the LCD (from the left) will allow you to configure the mix bus (in PAIRS, actually) between Pre EQ, Post EQ, Pre Fader, Post Fader or SubGroup.Select your configuration of choice and press the rotary encoder to commit the change.&nbsp; You&#039;ll probably have to follow-up by hitting the &quot;Yes&quot; (Page Select right) to confirm, because you&#039;re only able to assign in pairs, and this change will impact 2 mix busses.I hope I&#039;ve understood what you&#039;re looking to do - if not, my apologies...Don</blockquote>

[QUOTE="Donald P Leaman, post: 65358, member: 1762"] re: X32 Discussion Try this: Press the "Sends on Fader" button Press the "Home" button next to the LCD screen Use the right-arrow to move to the "Config" tab Select the bus you want to configure by hitting it's "Select" button in the master section (make sure you're on "bus 1-8" or "bus 9-16") Now, the 3rd rotary knob below the LCD (from the left) will allow you to configure the mix bus (in PAIRS, actually) between Pre EQ, Post EQ, Pre Fader, Post Fader or SubGroup. Select your configuration of choice and press the rotary encoder to commit the change. You'll probably have to follow-up by hitting the "Yes" (Page Select right) to confirm, because you're only able to assign in pairs, and this change will impact 2 mix busses. I hope I've understood what you're looking to do - if not, my apologies... Don [/QUOTE]

Verification