Reply to thread

Message

<blockquote data-quote="Jan Tapak" data-source="post: 66012" data-attributes="member: 1294">re: X32 DiscussionHi&nbsp; All,&nbsp;Thank you a lot for good information on the forum.I would like to ask you, because soon I will have 2 pieces of X32.If 2 consoles X32 are connected via AES50a, can I do routing like following?:&nbsp;1st. FOH: In the Setup&gt; to choose -&gt; Card -&gt;Interface-&gt; FireWire-&gt;32in/32out&nbsp;2[SUP]nd[/SUP]:Inputs: Stage -&gt; Monitor X32 to route Local 1-32 -&gt;via AES50a-&gt; FOH mix X32, then mirroring all 32 channels to FiWi card (routing on card will be AES50A1 to AES50A32). Here on the PC, I would like to run VST host program. And then on the FOH X32 in Home Routing to select inputs (Card 1-32) to do the rest of FOH work.&nbsp;3[SUP]rd[/SUP]:Outputs:&nbsp;FOH X32 to route output to AES50a: MainL post Fader to Output1 ; MainR post Fader to Output2 (Out 1-8 are routed to AES50A 1-8 by default)Monitor X32: Routing-&gt;Home-&gt; Assign AUX1-4 to AES50A A1-4 (Output 15 -&gt; Direct out AUX1 pre EQ; Output 16 -&gt; Direct out AUX2 pre EQ)&nbsp;Did somebody do this config? What about latency, delay of FOH sound,…? What could be a problem with this configuration? Where do you see a bottleneck?Thank you for your comments.</blockquote>

[QUOTE="Jan Tapak, post: 66012, member: 1294"] re: X32 Discussion Hi All, Thank you a lot for good information on the forum. I would like to ask you, because soon I will have 2 pieces of X32. If 2 consoles X32 are connected via AES50a, can I do routing like following?: 1st. FOH: In the Setup> to choose -> Card ->Interface-> FireWire->32in/32out 2[SUP]nd[/SUP]: Inputs: Stage -> Monitor X32 to route Local 1-32 ->via AES50a-> FOH mix X32, then mirroring all 32 channels to FiWi card (routing on card will be AES50A1 to AES50A32). Here on the PC, I would like to run VST host program. And then on the FOH X32 in Home Routing to select inputs (Card 1-32) to do the rest of FOH work. 3[SUP]rd[/SUP]: Outputs: FOH X32 to route output to AES50a: MainL post Fader to Output1 ; MainR post Fader to Output2 (Out 1-8 are routed to AES50A 1-8 by default) Monitor X32: Routing->Home-> Assign AUX1-4 to AES50A A1-4 (Output 15 -> Direct out AUX1 pre EQ; Output 16 -> Direct out AUX2 pre EQ) Did somebody do this config? What about latency, delay of FOH sound,…? What could be a problem with this configuration? Where do you see a bottleneck? Thank you for your comments. [/QUOTE]

Verification