Reply to thread

Message

<blockquote data-quote="Jaap Geurts van Kessel" data-source="post: 66371" data-attributes="member: 2232">re: X32 DiscussionHi Joe,I&#039;m especially interested in the following:- Configuring DCA, Subgroups and Matrix Mixes- P16 and the X32 - Overview and complete setup- DAW - I/O and Control Surface- Reaper and the X32Another general question:Is it possible to connect a midi-instrument (keyboard/drums) to the midi port of the X32? The manual states the port is for: &quot;Sending and recieving MIDI commands via 5-pin DIN cables.&quot; So I quess that&#039;s a no. But maybe I&#039;m wrong. I tried opening the port in Reaper but it says something along the lines of &#039;Unable to open up the midi input on X_UF&#039;The &#039;MIDI In/Out&#039; and Card MIDI are set to &#039;on&#039; in the Remote Tab. MIDI remote works fine too in Reaper.</blockquote>

[QUOTE="Jaap Geurts van Kessel, post: 66371, member: 2232"] re: X32 Discussion Hi Joe, I'm especially interested in the following: - Configuring DCA, Subgroups and Matrix Mixes - P16 and the X32 - Overview and complete setup - DAW - I/O and Control Surface - Reaper and the X32 Another general question: Is it possible to connect a midi-instrument (keyboard/drums) to the midi port of the X32? The manual states the port is for: "Sending and recieving MIDI [U]commands[/U] via 5-pin DIN cables." So I quess that's a no. But maybe I'm wrong. I tried opening the port in Reaper but it says something along the lines of 'Unable to open up the midi input on X_UF' The 'MIDI In/Out' and Card MIDI are set to 'on' in the Remote Tab. MIDI remote works fine too in Reaper. [/QUOTE]

Verification