Reply to thread

Message

<blockquote data-quote="John DiNicola" data-source="post: 66964" data-attributes="member: 2061">Re: X32 DiscussionHi Liam,By default, the first 4 FX processors are fed by mix busses 13-16. The Vintage Room is routed to the first slot (Bus 13) by default.&nbsp; To hear this reverb, all you should have to do is raise the send to Bus 13 on whichever channels you would like fed to the Reverb. You will need to make sure the master Bus Send for Bus 13 is turned up (using the third layer on the right side of the console, labeled BUS 9-16). The return for this effect will appear on the 3rd layer on the left (input) side of the console (labeled AUX IN / USB / FX RETURNS). Remember that you can reset your console to the default configuration at any time by engaging the Initialize Console option on the &quot;Config&quot; tab of the SETUP menu. This might help when trying to follow the manual. If you need anymore assistance, PM me anytime.Best,John DiNicolaSenior Specialist, Product SupportMUSIC GroupBEHRINGER</blockquote>

[QUOTE="John DiNicola, post: 66964, member: 2061"] Re: X32 Discussion Hi Liam, By default, the first 4 FX processors are fed by mix busses 13-16. The Vintage Room is routed to the first slot (Bus 13) by default. To hear this reverb, all you should have to do is raise the send to Bus 13 on whichever channels you would like fed to the Reverb. You will need to make sure the master Bus Send for Bus 13 is turned up (using the third layer on the right side of the console, labeled BUS 9-16). The return for this effect will appear on the 3rd layer on the left (input) side of the console (labeled AUX IN / USB / FX RETURNS). Remember that you can reset your console to the default configuration at any time by engaging the Initialize Console option on the "Config" tab of the SETUP menu. This might help when trying to follow the manual. If you need anymore assistance, PM me anytime. Best, John DiNicola Senior Specialist, Product Support MUSIC Group BEHRINGER [/QUOTE]

Verification