Reply to thread

Message

<blockquote data-quote="Jef Bass" data-source="post: 71706" data-attributes="member: 1882">Firmware and patching concernsI will throw this one out there and ask for your feed back.&nbsp; In a recent conversation with the folks at Behringer Support, I was made aware of the fact that currently there is no way to individually route outputs of the desk to designated S16&#039;s.&nbsp; For example, If you have three S16&#039;s, located around your stage in different areas, you can only send the same outs to each ones.&nbsp; I want to be able to send certain feeds to S16-A versus S16-B versus S16-C.&nbsp; This lessens the amount of long mic cable runs and cleans up the stage environment. How hard would it be to have an output &quot;jack&quot; selection on the main page of the buss/matrix/main page where you can route to any male XLR you choose (ADAT and 1/4&quot; are included in the same thought)?Again, I ask for input here in case I am missing something, but would it not be prudent to offer a choice on the firmware of the X32 to function like it does now for the general user, and perhaps offer an &quot;expert mode&quot; which would facilitate detailed patching options?&nbsp; Not to mention that other options could be written into expert mode that some of us have been asking for. Also, how much processing power does it take to run one of the effects chains?&nbsp; Is it enough that if there was an option in said &quot;expert mode&quot; to allow us to give up one effects processor for full channel functionality on all the aux return channels thus making the X32 into a full 40 channel desk?&nbsp; Of course this could only be activated in the presence of at least on S16....Let&#039;s hope that your feelings are the same as mine and the idea makes it up the chain as well....</blockquote>

[QUOTE="Jef Bass, post: 71706, member: 1882"] Firmware and patching concerns I will throw this one out there and ask for your feed back. In a recent conversation with the folks at Behringer Support, I was made aware of the fact that currently there is no way to individually route outputs of the desk to designated S16's. For example, If you have three S16's, located around your stage in different areas, you can only send the same outs to each ones. I want to be able to send certain feeds to S16-A versus S16-B versus S16-C. This lessens the amount of long mic cable runs and cleans up the stage environment. How hard would it be to have an output "jack" selection on the main page of the buss/matrix/main page where you can route to any male XLR you choose (ADAT and 1/4" are included in the same thought)? Again, I ask for input here in case I am missing something, but would it not be prudent to offer a choice on the firmware of the X32 to function like it does now for the general user, and perhaps offer an "expert mode" which would facilitate detailed patching options? Not to mention that other options could be written into expert mode that some of us have been asking for. Also, how much processing power does it take to run one of the effects chains? Is it enough that if there was an option in said "expert mode" to allow us to give up one effects processor for full channel functionality on all the aux return channels thus making the X32 into a full 40 channel desk? Of course this could only be activated in the presence of at least on S16.... Let's hope that your feelings are the same as mine and the idea makes it up the chain as well.... [/QUOTE]

Verification