Reply to thread

Message: <blockquote data-quote="Dick Franks" data-source="post: 71709" data-attributes="member: 2130">Re: Firmware and patching concerns I don't think the information you received is accurate.  For example, you can set Outputs 1-8 on one S16, and then 9-16 on a second S16.  Then on the ouput routing page, you can assign an X32 output to any one of the 16 S16 outputs.  So if I had an S16 on each side of the stage, I could set Out 8 on one S16 to be the left main signal, and Out 8 on the second S16 (which would actually be ouput 16) to be the right main signal.  Or if you had an S16 on the back line, you could send Buss 5 (drum monitor mix) to any of the Outs (9-16) for his monitor feed.</blockquote>

Top Bottom