Re: S16's ( dummies guide!)
A bit stuck with this:
I have the S16's connected as follows
AES50A on X32 to S16(1) AES50 A
S16(1) AES50B to S16(2) AES50A
On the home routing screen under AES50 A it shows I have two S16s connected.
However I cannot get the two S16s to Sync together
The first S16(1) is synced to the X32 - the clock input on the X32 is set to AES50A as the source and on the S16(1) the sync is set to master at 44.1KHZ
I presumed that on the S16(2) I would simply set this to slave ( but not sure how to do this!) going through the config options I have the 4 master clock options and then it goes onto the split etc which turns off the master sync - but then the sync(ing) light which was flashing showing no sync or trying to sync goes out completely - the link light on the S16(1)- ( again which was flashing - presume trying to link) also goes out.
Sorry not too clear!!!
Will play around some more but help from someone who has set this up would be welcome
many thanks
Nick
