Normal
Re: Firmware v1.10 Release NotesAll,THis might help a few people with USB stick issues. It is not a fix for all USB sticks but probably many. If you try and load the new firmware from your usb stick and it does not see the firmware on the stick and boots normally. Then try this, go into 'Setup' and find the setting for the sample rate. Change it from what you are using, probably 44.1K, to 48K and save. This will force a reboot. During this reboot it is far more likely that the new firmware will be seen on the USB stick and will get installed. Once done, go change the sample rate back to what you normally use and save. Another reboot will take place and off you go.Mike
Re: Firmware v1.10 Release Notes
All,
THis might help a few people with USB stick issues. It is not a fix for all USB sticks but probably many. If you try and load the new firmware from your usb stick and it does not see the firmware on the stick and boots normally. Then try this, go into 'Setup' and find the setting for the sample rate. Change it from what you are using, probably 44.1K, to 48K and save. This will force a reboot. During this reboot it is far more likely that the new firmware will be seen on the USB stick and will get installed. Once done, go change the sample rate back to what you normally use and save. Another reboot will take place and off you go.
Mike
