Reply to thread

Message

<blockquote data-quote="Chase McKnight" data-source="post: 74394" data-attributes="member: 2256">Re: Solo in place?&nbsp; Eq paring?Hello Everyone,As there have been several inquiries regarding the X32 noise issue, I wanted to address the concern.&nbsp; As Joe stated, there was an issue with the internal routing of cables running too close to the DSP chips.&nbsp; We found this very early in the production cycle and re-routed the cables to eliminate the noise that was being amplified due to the current routing.&nbsp; Once the change was made in manufacturing, we were able to re-route all products that had not shipped.&nbsp;The cable rerouting in itself is a very simple fix.&nbsp; However, due to the overall assembly and the complexity of the board itself, it is recommended that the reroute is done by qualified individuals only.&nbsp; As such, if you are experiencing noise on your monitor outs, please contact us directly by any of the means below.&nbsp; We will be able to confirm the issue and make arrangements to resolve this, or any issue you have with your X32.&nbsp;<a href="http://www.behringer.com/support" target="_blank">BEHRINGER: Support</a><a href="mailto:care@music-group.com">care@music-group.com</a>US/Canada - +1 702-800-8290EMEA - + (44) 1562 732290Please PM or call me directly at (702) 371-0830 if you&#039;re having any issues.&nbsp; If you&#039;re outside the US, feel free to PM me and I&#039;ll get you in contact with someone that can help!Kind regards,Chase McKnightJr. Admin, Technical SupportMUSIC GroupBEHRINGER</blockquote>

[QUOTE="Chase McKnight, post: 74394, member: 2256"] Re: Solo in place? Eq paring? Hello Everyone, As there have been several inquiries regarding the X32 noise issue, I wanted to address the concern. As Joe stated, there was an issue with the internal routing of cables running too close to the DSP chips. We found this very early in the production cycle and re-routed the cables to eliminate the noise that was being amplified due to the current routing. Once the change was made in manufacturing, we were able to re-route all products that had not shipped. The cable rerouting in itself is a very simple fix. However, due to the overall assembly and the complexity of the board itself, it is recommended that the reroute is done by qualified individuals only. As such, if you are experiencing noise on your monitor outs, please contact us directly by any of the means below. We will be able to confirm the issue and make arrangements to resolve this, or any issue you have with your X32. [url=http://www.behringer.com/support]BEHRINGER: Support[/url] [email]care@music-group.com[/email] US/Canada - +1 702-800-8290 EMEA - + (44) 1562 732290 Please PM or call me directly at (702) 371-0830 if you're having any issues. If you're outside the US, feel free to PM me and I'll get you in contact with someone that can help! Kind regards, Chase McKnight Jr. Admin, Technical Support MUSIC Group BEHRINGER [/QUOTE]

Verification