Reply to thread

Message

<blockquote data-quote="JÃ¶rgen Gustavsson" data-source="post: 74502" data-attributes="member: 1734">Re: Change routing without losing gain settings and 48VIf you put in a S16 to add more inputs copy settings can be wrong.But if you move adjusted sets of inputs(8channels) from one unit to another there should be an option to copy settings then you do the switch. f.eg.*&nbsp; You have done several different shows with X32 last year. This year you have 2 S16 and want to change routing then you a repeat a show from last year. Not writing down all gain settings on a paper and adjust all channels.*&nbsp; You have have done setup with 2 S16. Drums are on ch 1-8 on the first one of them. But you put another S16 to set next to the drums and want to route ch 1-8 here. Gain settings should follow the channels.*&nbsp; I have thought of X32 inputs to be a backup if S16 goes down on small gigs. CAT5 can be cut or S16 smoked by a bear or internal fail. Take X32 to stage, plug in all inputs directly to X32, change the routing and mix with ipad.&nbsp;&nbsp; There is only one thing, Gain settings are not copied. And you have to write them down when S16 is alive. Then S16 is disconnected you cant read the gain value. If don&#039;t have the values, you have to let the band play to set the gain.&nbsp;&nbsp; And if gain differ from sound check, you can correct PA with ipad but this will affect monitors as well.Copy Gain settings and 48V can help you a lot in some situations. If where are another way to copy those settings I&#039;m on. But I think I&#039;ve tested all of them. If Routing and 48V wasn&#039;t tied together with others in Scene Safes that could be ok.Hope this can be as an option in future firmware (if you want to copy or not). Writing down all settings seems a little SL-way...Best RegardsJörgen</blockquote>

[QUOTE="JÃ¶rgen Gustavsson, post: 74502, member: 1734"] Re: Change routing without losing gain settings and 48V If you put in a S16 to add more inputs copy settings can be wrong. But if you move adjusted sets of inputs(8channels) from one unit to another there should be an option to copy settings then you do the switch. f.eg. * You have done several different shows with X32 last year. This year you have 2 S16 and want to change routing then you a repeat a show from last year. Not writing down all gain settings on a paper and adjust all channels. * You have have done setup with 2 S16. Drums are on ch 1-8 on the first one of them. But you put another S16 to set next to the drums and want to route ch 1-8 here. Gain settings should follow the channels. * I have thought of X32 inputs to be a backup if S16 goes down on small gigs. CAT5 can be cut or S16 smoked by a bear or internal fail. Take X32 to stage, plug in all inputs directly to X32, change the routing and mix with ipad. There is only one thing, Gain settings are not copied. And you have to write them down when S16 is alive. Then S16 is disconnected you cant read the gain value. If don't have the values, you have to let the band play to set the gain. And if gain differ from sound check, you can correct PA with ipad but this will affect monitors as well. Copy Gain settings and 48V can help you a lot in some situations. If where are another way to copy those settings I'm on. But I think I've tested all of them. If Routing and 48V wasn't tied together with others in Scene Safes that could be ok. Hope this can be as an option in future firmware (if you want to copy or not). Writing down all settings seems a little SL-way... Best Regards Jörgen [/QUOTE]

Verification