Reply to thread

Message

<blockquote data-quote="Jere Malila" data-source="post: 75267" data-attributes="member: 3077">Problems with brand new X32 out of box.Hi,I&#039;m having a brand new X32, but I have few problems:- High extra noise on channels 16 &amp; 32. - Fader number 2 is occasionally much slower than others and seems to have some &#039;startup&#039; problems. After one/two days of unusage fader nbr 2 hardly has enough power to move at first movement.- Some buttons are &#039;sticky&#039;. Example master mute is &#039;very&#039; sticky. Master block seems to also be little lose as you can see scripple strip &#039;wobble&#039; if you press mute with some force. - Occasional cracks and pops when playing something thru USB from OSX 10.8... maybe I should contact support right away and ask for replacement of desk, not service. Firmware which was at at desk when it arrived was 1.02. So it&#039;s from early days of production?I feel that QC is badly failed on this desk.</blockquote>

[QUOTE="Jere Malila, post: 75267, member: 3077"] Problems with brand new X32 out of box. Hi, I'm having a brand new X32, but I have few problems: - High extra noise on channels 16 & 32. - Fader number 2 is occasionally much slower than others and seems to have some 'startup' problems. After one/two days of unusage fader nbr 2 hardly has enough power to move at first movement. - Some buttons are 'sticky'. Example master mute is 'very' sticky. Master block seems to also be little lose as you can see scripple strip 'wobble' if you press mute with some force. - Occasional cracks and pops when playing something thru USB from OSX 10.8 ... maybe I should contact support right away and ask for replacement of desk, not service. Firmware which was at at desk when it arrived was 1.02. So it's from early days of production? I feel that QC is badly failed on this desk. [/QUOTE]

Verification