Normal
Re: AC and signal cable of whatever typeAnd how is the shield connected to ground? The barrel of an XLR is an unreliable connection, and I presume the barrel of an Ethercon is the same way, if you could figure out a way to mechanically connect to it. There is not a provision to do so in the Ethercon connector.This is all good information, thanks for posting it, but there is that one little detail....Will this be covered in the Webinar tomorrow?
Re: AC and signal cable of whatever type
And how is the shield connected to ground? The barrel of an XLR is an unreliable connection, and I presume the barrel of an Ethercon is the same way, if you could figure out a way to mechanically connect to it. There is not a provision to do so in the Ethercon connector.
This is all good information, thanks for posting it, but there is that one little detail....
Will this be covered in the Webinar tomorrow?
