Reply to thread

Message

<blockquote data-quote="Dragos Strat" data-source="post: 91528" data-attributes="member: 4461">Re: X32 DiscussionOK, now I understood, you just simplified the explanation to dumb animals (also a song of handsome furs) and I flowed you till the end. Regarding the weak gain signal - I discovered it depends on input configuration you use. When I use Card 1-8 as input, the channel strip gain knob its acting independently of setup-preams section A/D gain. Practically I can raise it to have a hot signal by rotating the push rotary knob on the preamp section even I already have the channel strip gain all the way up. Its not the same gain as the knob located on channel strip. When I use Local 1-8 as input, the channel strip gain knob its indeed, acting together with setup-preams section A/D gain. But only with this configuration.So its possible to have a weak signal and make it hotter when you use card 1-8 input using A/D gain even you have dialled the channel gain up . Just described what I fund by trial. Don&#039;t now if its good or bad to raise A/D gain. For me just makes sense to rise it and have a proper input gain if my input is weak.Sorry to everyone if I took over this tread. I&#039;m in a learning process from zero. Till now I was just a guitarist reading only about valves, pedals and strings. I cannot find anywhere all the infos that you gave me or to others on this tread. its the most valued place for a beginner on x32 features. I promise not to be so insistent in the future.Tank you very much!</blockquote>

[QUOTE="Dragos Strat, post: 91528, member: 4461"] Re: X32 Discussion OK, now I understood, you just simplified the explanation to dumb animals (also a song of handsome furs) and I flowed you till the end. Regarding the weak gain signal - I discovered it depends on input configuration you use. When I use Card 1-8 as input, the channel strip gain knob its acting independently of setup-preams section A/D gain. Practically I can raise it to have a hot signal by rotating the push rotary knob on the preamp section even I already have the channel strip gain all the way up. Its not the same gain as the knob located on channel strip. When I use Local 1-8 as input, the channel strip gain knob its indeed, acting together with setup-preams section A/D gain. But only with this configuration. So its possible to have a weak signal and make it hotter when you use card 1-8 input using A/D gain even you have dialled the channel gain up . Just described what I fund by trial. Don't now if its good or bad to raise A/D gain. For me just makes sense to rise it and have a proper input gain if my input is weak. Sorry to everyone if I took over this tread. I'm in a learning process from zero. Till now I was just a guitarist reading only about valves, pedals and strings. I cannot find anywhere all the infos that you gave me or to others on this tread. its the most valued place for a beginner on x32 features. I promise not to be so insistent in the future.Tank you very much! [/QUOTE]

Verification