Reply to thread

Message

<blockquote data-quote="Alan Hamilton" data-source="post: 92427" data-attributes="member: 1799">Re: X32 PermissionsWell... Put me down in the problematic X32 category. Pres 1-8 wouldn&#039;t pass signal. Doublechecked routing and it looked fine to me. I moved the audio snake chs 1-8 to pres 17-24 and routed them to the 1-8 layer and it worked fine. But anything connected to pres 1-8 didn&#039;t matter where they were routed, nada... nogo... silence. I did a reboot (twice even), loaded an old scene... no change. Problem remained. LMK if I&#039;m forgetting something... I&#039;m thinking hardware issue though. I&#039;m getting a ribbon cable problem kind of vibe... <img src="https://cdn.jsdelivr.net/joypixels/assets/8.0/png/unicode/64/1f609.png" class="smilie smilie--emoji" loading="lazy" width="64" height="64" alt=";)" title="Wink&nbsp; &nbsp; ;)"&nbsp; data-smilie="2"data-shortname=";)" />Never acted up previously. Worked fine at the last show it was on. Board has not even been used that much and always in a roadcase.-AlanH</blockquote>

[QUOTE="Alan Hamilton, post: 92427, member: 1799"] Re: X32 Permissions Well... Put me down in the problematic X32 category. Pres 1-8 wouldn't pass signal. Doublechecked routing and it looked fine to me. I moved the audio snake chs 1-8 to pres 17-24 and routed them to the 1-8 layer and it worked fine. But anything connected to pres 1-8 didn't matter where they were routed, nada... nogo... silence. I did a reboot (twice even), loaded an old scene... no change. Problem remained. LMK if I'm forgetting something... I'm thinking hardware issue though. I'm getting a ribbon cable problem kind of vibe... ;) Never acted up previously. Worked fine at the last show it was on. Board has not even been used that much and always in a roadcase. -AlanH [/QUOTE]

Verification