Reply to thread

Message

<blockquote data-quote="Joseph Schuurman" data-source="post: 93222" data-attributes="member: 4464">Re: Pop. crackle and feedback problemsStrange, might have just been an accidental change, this setting was mostly setup when we first setup the board, so we were still mis-navigating and such.&nbsp; Generally, our bus faders do infact affect the actual output to the montitors.What is the benefit of setting it up as a matrix over simple bus?&nbsp; Matrix, is one area which I don&#039;t fully understand yet.&nbsp; As I understand it, the main&#039;s L/R are a matrix, I assume that&#039;s because it has all inputs, then it also has all effects, eq, compressor/limitor, etc.. affecting all those inputs (on a per input basis), making it a matrix.&nbsp; Do I have that right?&nbsp; So by making a monitor output a matrix, I get the benefit of being able to configure each channel&#039;s settings individually, rather than just having control (eq/compressor/limiter/etc..) over the mix bus?</blockquote>

[QUOTE="Joseph Schuurman, post: 93222, member: 4464"] Re: Pop. crackle and feedback problems Strange, might have just been an accidental change, this setting was mostly setup when we first setup the board, so we were still mis-navigating and such. Generally, our bus faders do infact affect the actual output to the montitors. What is the benefit of setting it up as a matrix over simple bus? Matrix, is one area which I don't fully understand yet. As I understand it, the main's L/R are a matrix, I assume that's because it has all inputs, then it also has all effects, eq, compressor/limitor, etc.. affecting all those inputs (on a per input basis), making it a matrix. Do I have that right? So by making a monitor output a matrix, I get the benefit of being able to configure each channel's settings individually, rather than just having control (eq/compressor/limiter/etc..) over the mix bus? [/QUOTE]

Verification