X32 edit setup for vocal effects with vocalist

J

Jovance Todorov

Freshman
Jul 27, 2014
48
0
0
[h=2][/h]
Dear friend, I have one question about X32 edit software.
I have TYROS 5 keyboard who is linked to X32 with 4 cables. MAIN OUT1 is linked to chanel 15 on mixer. MAIN OUT2 is linked to chanel 16 on mixer. SUB OUT1 is linked to chanel 13 on mixer. SUB OUT is linked to chanel 14on mixer.
AUX OUT 1 on mixer is linked with microphone out on keyboard. I want to set vocal harmony on chanels 1-12 for all 12 microphones, but a I didn't have that effect on chanells 13-16.
How to set up this on X32 edit?​
 
Re: X32 edit setup for vocal effects with vocalist

First of all, I think you mean that you have connected the aux out of the mixer to the Microphone In of the Tyros.
to send a signal from channel 1 to 12 you have to send it to a mixbus and then on the routing page for aux outs you have to assign aux out 1 to that mixbus. The mixbus can be configured as pre/post fader or as Subgroup depending on your needs.
all these configuration can be done on the X32 or on the, connected, X32 edit.
 
Top Bottom