Recent content by drew gandy

I finally figured it out. The secret key combo is "MUTE GRP + UTILITY" and then you have 4 tabs. The Home tab is where you actually use the knobs you set on the SETs A,B and C tabs. I used SET C to setup basic fader control of 4 channels. To use it I have the HOME tab active and arrowed down...

There used to be a key combo that would jump you to "page C" where you could assign the front panel knobs to channel faders etc. My Google Fu is weak. I'm not finding the instructions for this. And I suspect that it was changed in version 4 of the firmware? Anyone still use this? Or remember how...

You're probably right about the economics. But it would seem to me that a professional loudspeaker would be the ideal item to try recycle. There's a much larger piece of magnet there than in all the small devices. And given the concern that the US gov and military seem to have about the supply...

Given the political and geographical situation with rare earth metals, I've been curious about the recyclability of speaker magnets. In my travels I've never heard any talk about this from manufacturers or anywhere else. I've got a handful of B&C woofers that, despite the availability of recone...

Fight fire with fire? Set up your own subwoofer system (tell the other neighbors that it's only to teach this guy a lesson), find out when he sleeps and then crank it away (at legal levels) so that he gets the point. I've had thoughts over the years about building a bass array into the back...

I haven't tried any of the little all-in-one short throws but have some experience with the Panasonic DLP projectors with the ET-DLE030 lens. At $5k for the lens alone, it certainly doesn't fit your budget but with 6-7k lumen projectors on screens as wide as 12' I've found the Panasonics to be...

So, were the PM boxes contaminating the Vertec's? Or vice versa? ;)

It's been a long time since I looked at solid state analog audio switching chips but I seem to recall that most of them had less than "studio grade" distortion specs. Relays, despite their other issues were often the better way to accomplish this without disturbing the signal. In today's world...

Anyone have experience with this? I'm looking for a low cost way to add a few wireless coms to a system for occasional use. Their cloud version looks like reasonable pricing except that it doesn't apparently support wiring into another intercom system. I would think that one client...

I'm trying to figure out what camera this fits. Any veterans out there who might know? http://avequipment.postach.io/post/camera-component-cable

Old square magnet woof woof. I'm curious what it is (I can't remember where it came from) and perhaps if anyone is interested in owning it. http://avequipment.postach.io/post/15-woofer-not-sure-what-it-is

I've seen these in the catalogs (Da-Lite dual vision etc) and may have used one once a long time ago but don't really have enough experience with them to have an opinion. So, I'm looking for opinions. Obviously, the "gain" is going to be low compared to a dedicated front or rear on account of...

http://avequipment.postach.io/sony-dsc-1024hd Make an offer. Located near Chicago. I have lots of other stuff that will be posted to the postach.io site soon so peek around. You can send me a PM here and I should get it. Thanks,

This is a wish list item. Come up with a way to avoid the "coat sleeve surprise". I want the console to ignore inadvertent volume boosts when I catch a fader knob with my coat sleeve. :lol: Some of you know what I'm talking about. Looking at this realistically, I wonder if it is possible...

I'm looking forward to the day when you can unload the truck into the shop and the system will automatically know what came back and therefore also what didn't come back. I haven't been following RFID closely but I did just happen upon this product that was launched via kickstarter...