I have two 8 ohm subs I'd like to connect to my nu3000DSP as a single 4 ohm load. When running an iNuke nu3000DSP in bridged mode, can I hang one of the subs off each output, or do I need to actually cascade them (in parallel) off a single output?
(In other words; do the outputs become wired in parallel when the amp is running in bridged mode?)
The manual says "The mono output signal isidentical at Outputs A and B, and the amplifier responds to a single combinedspeaker load", which seems to suggest that the loads across each output are in parallel, and my two individual 8 ohm subs would be seen as a single 4 ohm (combined) load. Yeah?
Thanks,
Mitch
(In other words; do the outputs become wired in parallel when the amp is running in bridged mode?)
The manual says "The mono output signal isidentical at Outputs A and B, and the amplifier responds to a single combinedspeaker load", which seems to suggest that the loads across each output are in parallel, and my two individual 8 ohm subs would be seen as a single 4 ohm (combined) load. Yeah?
Thanks,
Mitch