Is there a way to bump up the master level meter on an LS9-32 to match the input meters on the IT amps?
Right now, when the LS9-32's meters are at -18, the IT's input meters are at clip and the outputs are touching Limits. This doesn't bother me with the mixer outs showing so low on the board
However, when a BE works on the desk they want to run the mixer close to the clip lights on the board. Inorder to make him happy for the night I backed down the IT levels down 18-20 db per amp (but that only affected the out levels and the Input meter stayed in Clip the entire time).
I think my IT amps input are set to 1.4v with analog inputs.
Right now, when the LS9-32's meters are at -18, the IT's input meters are at clip and the outputs are touching Limits. This doesn't bother me with the mixer outs showing so low on the board
However, when a BE works on the desk they want to run the mixer close to the clip lights on the board. Inorder to make him happy for the night I backed down the IT levels down 18-20 db per amp (but that only affected the out levels and the Input meter stayed in Clip the entire time).
I think my IT amps input are set to 1.4v with analog inputs.