Re: 4 x EAW KF730 rolling carts
Shane, are you going to connect the bumper bar to the frame? if so, at which points?
Hi Phil, no, I'll probably use welded metal "stops" around the outside of the bumper to keep itin place, and not - pin or lock it in... The same way I do now with the wooden dolly top, it's bascially a raised outline of the bumper. It might have to be something I can swing out of the way, on some sort of large bar, and wingnut arrangement, to lock it in place once it's landed... R&D to follow
@ Brandon - moving the next four boxes into place shouldn't be difficult, since the top of rack two will be wide open. it'll be no more difficult than lining the boxes up now.
Basically now I'm flying the boxes in pairs... they come off the dolly, and sit upright as they will flying, on a roadcase ( 24" trunk).
I lower the bumper onto the stack of two, and pin the the first one into place, bump the motor, and pin the second box.
Raise the whole thing up where I can stack two more boxes, and repeat... so I can't see lowering the four flying boxes over top of a static rack of four more, would be any more difficult...and I'm only doing 4 pins... The only tough two would be the front two, the back probably has some sort of splay on it, which will make it easier to align.